Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
- 12. Mechanical transmission
12.2. General information
12.3. Adjustment of draft of the mechanism of a choice of transfers
12.4. Knot of the lever of gear shifting
12.5. Draft of the mechanism of a choice of transfers
12.6. Gear shifting lever
12.7. Protective cover of the lever of gear shifting
12.8. Sealing rings of differential
12.9. Sealing ring of an entrance shaft of a transmission
12.10. Removal and transmission installation
12.11. Transmission repair
12.12. Speedometer drive
12.13. Switch of lamps of a backing
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions
For performance of this operation it is necessary to use a stripper of spherical hinges. At installation it is necessary to use a new lock ring of a power shaft and new шплинт, fixing a nut of the spherical hinge connecting the bottom lever from a resistant forward suspension bracket.
| PERFORMANCE ORDER
| 1. It is possible to replace sealing rings of bearings of differential on a transmission established in the car.
| 2. At existence remove a cap from a forward wheel, then weaken bolts of fastening of a wheel. Tighten the hand brake, then lift a forward part of the car and fix on supports. Unscrew bolts and remove a forward wheel.
| 3. Take шплинт, then unscrew the koronchaty nut, fixing the spherical hinge connecting the bottom lever from a resistant forward suspension bracket.
|4. Using a stripper of spherical hinges, squeeze out a pin of the spherical hinge.
| 5. Having pulled a nave of a forward wheel outside, take from differential the internal end of a power shaft. Using a soft wire, adhere the internal end of a power shaft to a body.
|6. Using a screw-driver edge as the lever, take a sealing ring from differential.
| PERFORMANCE ORDER
| 1. Grease working edges of a new sealing ring with transmission oil, then, using a tubular opravka of the corresponding diameter, establish a new sealing ring in a differential nest.
| 2. Establish in a flute on the internal end of a power shaft a new lock ring and insert a power shaft into differential.
| 3. Establish the spherical hinge connecting the bottom lever of a forward suspension bracket from a resistant suspension bracket and screw a koronchaty nut on a pin of the hinge and tighten it the demanded moment. Insert new шплинт, fixing a nut from unscrewing.
|4. Establish a wheel, then lower the car on the earth and finally tighten bolts of fastening of a wheel. At existence establish a wheel cap.
| 5. Check and, if necessary, finish to norm oil level in a transmission.