1. Remove the stabilizer of cross-section stability. |
2. For replacement of the adjusting plug on the end of the stabilizer of cross-section stability fix the stabilizer in a vice with soft sponges and, using a kiyanka and a drift, bring down a tip from the stabilizer. |
3. Using a screw-driver edge as the lever, remove the plug from a stabilizer tip. |
4. Moisten the new plug with soap water and insert it into a stabilizer tip. |
5. Similarly replace the second tip of the stabilizer. |
6. After removal of one of tips from the stabilizer it is possible to make replacement of plugs of fastening of the stabilizer to the bottom forward frame. For this purpose simply pull together the plug on the stabilizer and in the same way establish the new plug. |
7. Establish a tip on the stabilizer of cross-section stability in the situation shown in drawing. |
8. Before installation of the stabilizer check a condition of rubber pillows of fastening of the stabilizer to the bottom lever and, if necessary, replace them. |
9. Establish the forward stabilizer of cross-section stability. |