1. Lift a back part of the car and fix on supports. |
2. Working under the car, remove brackets and take brake tubes from arms from two parties of the bottom of the car. Keep in mind that on brackets which brake tubes fix, wires of ABS sensors are fixed. |
3. Disconnect submitting fuel hose from the fuel filter which is located on the right side on the car bottom before a fuel tank. Close openings in the filter and a hose suitable jams. |
4. Support a jack a back cross-section beam and unscrew two bolts, fixing it. |
5. For access to arms of fastening of the stabilizer of cross-section stability to a back beam, being careful, lower a jack, thus do not stretch hoses, tubes and электричес a wire cue. |
6. Unscrew nuts and remove earrings of the stabilizer of cross-section stability from diagonal levers. Remove rubber pillows and rasporny plugs. |
7. Unscrew two bolts, fixing arms of the stabilizer of cross-section stability to a back beam and take the stabilizer from under the car (see drawing). |
8. If necessary remove earrings, having simply pulled together them from the stabilizer. |
9. Check a condition of adjusting plugs of the stabilizer of cross-section stability and if necessary, replace them. |
10. If necessary replace plugs on stabilizer earrings. |
11. For removal of adjusting plugs pull together them on the stabilizer after earring removal. Before installation new plugs moisten with soap water. |