Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
- 1.1 Maintenance
   1.2. Periodicity of service
   - 1.3. Maintenance
      1.3.1. Each 7500 km or 12 months
      + 1.3.2. Each 15 000 km or 12 months
      + 1.3.3. Complete service each 30 000 km or 24 months
      1.3.4. Main service. Each 60 000 km or 48 months
      1.3.5. Each 105 000 km or 84 months
      1.3.6. Each 120 000 km or 96 months
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


d476fba5


1.3.1. Each 7500 km or 12 months

Replacement of oil and oil filter (diesel engines)

GENERAL INFORMATION

Periodic replacement of oil and the oil filter – the most important preventive procedure of maintenance. When engine oil grows old, it becomes liquid and polluted that conducts to premature wear of the engine.

Before the beginning of this procedure gather all necessary tools and materials. It is necessary, that the engine was warm in order that oil flew down together with bulk of substances polluting it better.

Removal of a stopper from a maslozalivny mouth


Arrangement of a masloslivny stopper on the engine of 17 DT

PERFORMANCE ORDER
1. Establish the car on an equal horizontal platform (see fig. Removal of a stopper from a maslozalivny mouth).
2. Uncover a maslozalivny mouth.
3. Weaken a drain stopper approximately on a turn half (see fig. An arrangement of a masloslivny stopper on the engine of 17 DT). Place the container for oil plum under a drain stopper and unscrew a stopper completely. If it is necessary, press a stopper when unscrew that oil did not proceed prematurely.
4. When oil completely will flow down, move the container under the oil filter.
5. Use the special tool to weaken the oil filter, then unscrew it a hand.
6. Wipe all traces of oil and dirt round a place of fastening of the filter. Check, whether there was a rubber consolidation on the block of cylinders. If it remained, remove it.
7. Grease with a thin layer of engine oil rubber consolidation of the new oil filter and screw up the filter a hand, without using any tools.
8. Establish a wheel and lower the car on the earth.
9. Check a condition of ring consolidation of a masloslivny stopper. Wipe everything round a drain opening a rag and reliably screw up a masloslivny stopper into place.

10. Fill in oil in the engine, using the corresponding grade of oil. Fill in a half of necessary amount of oil and wait some minutes that oil flew down in the pallet, then continue to fill in oil in the small portions while level of oil will not reach a minimum level on щупе. At addition about one more liters level of oil will rise to maximum on щупе. Close a cover of a jellied mouth.

11. Start the engine and let's to it work some minutes. Check it about leakages of oil round the filter and a drain stopper on the pallet. Keep in mind that the control bulb of pressure of oil can burn some seconds as oil should fill all channels and oil capacities in the engine.
12. Switch off the engine and wait some minutes that oil flew down in the pallet. Check level of oil and add, if it is necessary.