Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Compression check
   4.5. Top dead point (VMT) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a cranked shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of a gazoraspredeleniye
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of a camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil radiator
   - 4.20. Pistons with rods
      4.20.1. Removal
      4.20.2. Check
      4.20.3. Installation
      4.20.4. Check of working gaps of shatunny bearings
      4.20.5. Installation of pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a cranked shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about engine removal
   4.25. Removal and engine installation
   4.26. Engine repair
   4.27. Engine start after major maintenance
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


d476fba5


4.20.4. Check of working gaps of shatunny bearings

GENERAL INFORMATION

Arrangement of a label of identification for definition of openings of the bottom head of a rod on the diesel engine

To selection of a working gap of the bearing of the bottom head of a rod apply three various loose leaves. Loose leaves are designated by a color label at an end face of each loose leaf which thickness increases depending on color in the following order: brown, black and dark blue. Bearings are delivered only the standard sizes.

If it is necessary to make replacement of bearings, make record идентифика the tsionny label put on a lateral surface of each rod (see drawing). Labels are used to choose the demanded size of the loose leaf of the bearing.
Loose leaf
Marking
I
The dark blue
II
The black
III
The brown