Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
- 8. Exhaust system and system of fall of toxicity of exhaust gases
   8.2. System of fall of toxicity of exhaust gases
   8.3. System of repeated burning of exhaust gases (EGR)
   8.4. The EGR valve (models with Multec system)
   8.5. EGR valve (Simtec system)
   8.6. EGR module (X16 SZ models)
   8.7. Knot of the air pump (Simtec system)
   8.8. Valve of an otsechka of system of reduction of toxicity
   8.9. The switching-off valve of system of reduction of toxicity
   8.10. Tube and unidirectional valve of system of reduction of toxicity
   8.11. Catalyst
   8.12. The canister with coal
   8.13. The oxygen sensor (models with the catalyst)
   8.14. Final collector
   - 8.15. Exhaust system
      8.15.1. A reception exhaust pipe on models with the SOHC engine
      8.15.2. A reception exhaust pipe on models with the DOHC engine
      8.15.3. Forward exhaust silencer or catalyst
      8.15.4. Central section
      8.15.5. Back section
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


d476fba5


8.15.4. Central section

Removal

Arrangement of the clip, fixing the central and back sections of an exhaust system on models with the SOHC engine

Arrangement of rubber pillows of fastening of the central section of an exhaust system on models with DOHC engines

PERFORMANCE ORDER
1. Lift the car and fix on supports or establish it over a viewing hole.
2. Unscrew a coupling bolt and disconnect the central section of an exhaust system from back section (see fig. An arrangement of the clip, fixing the central and back sections of an exhaust system on models with the SOHC engine). If necessary, use a hammer for division of sections of an exhaust system.
3. Unscrew nuts and bolts and disconnect the exhaust silencer or the catalyst from a connecting flange of the central section of an exhaust system. Remove laying.
4. Take the central section of an exhaust system from rubber pillows on the bottom of the car and take it from under the car (see fig. An arrangement of rubber pillows of fastening of the central section of an exhaust system on models with DOHC engines).

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. At installation use new laying on a connecting flange, and at connection of pipes of the central and back section of an exhaust system grease pipes with special paste for assembly of an exhaust system. Tighten all bolts and nuts the demanded moment.