Opel Vectra A

since 1988-1995 of release

Repair and car operation

Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
- 11. Transmission
   11.2. General information
   11.3. Coupling cable
   11.4. Adjustment of a cable of coupling
   11.5. Coupling pedal
   - 11.6. Couplings (the engine and a transmission are established in the car)
      11.6.2. Check
      11.6.3. Installation
   11.7. Coupling (the transmission is removed)
   11.8. Vyzhimna bearing
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


11.6.2. Check

1. Check overlays of a disk of coupling on wear, mechanical damages or pollution by oil.
2. In the presence of these defects it is necessary to replace a disk of coupling.
3. If frictional slips in a good condition also are not worn-out to grooves, springs of a damper are reliably fixed and zaklepochny connections are not loosened, it is possible to establish a disk of coupling in the car.
4. If the disk of coupling is polluted by oil, check the left oil sealing ring of a cranked shaft or primary shaft of a transmission. If necessary replace sealing rings before installation of a new disk of coupling.
5. Check knot of a leading disk on wear of a press disk, mechanical damages, reliability of zaklepochny connection, damage of a diafragmenny spring of coupling. If the spring of a diaphragm is worn-out or damaged, or there are suspicions that elasticity of a spring changed, it is necessary to replace knot of a leading disk.
6. Check working surfaces of a press disk and a flywheel, interfaced to overlays of a disk of coupling. They should be pure, flat and not have scratches and development.
7. Check press the bearing which should rotate easily, evenly and silently. The working surface of the bearing influencing a press spring, should be smooth, without cracks, local corrosion or development.