Opel Vectra A

since 1988-1995 of release

Repair and car operation

Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13.10. Central console
   13.11. Switches подрежима
   13.12. Electronic control device (ECU)
   13.13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13.14. Hoses and tubes of a radiator of cooling of transmission liquid
   13.15. Replacement of sealing rings of differential
   13.16. Sensor of temperature of transmission liquid
   13.17. Sensors of speed of rotation of entrance and target shaft
   13.18. Removal and installation of an automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


13.3. Replacement of transmission liquid

1. Before replacement of transmission liquid make a small control trip for transmission warming up to normal working temperature.
2. Establish the car on an equal horizontal platform, switch off ignition and tighten the hand brake. For improvement of access to a transmission lift a forward part of the car and fix on supports.
3. Take щуп for measurement of level of liquid in an automatic transmission, then establish the container under the drain stopper located in a back right part of a transmission under a power shaft, and unscrew a stopper.
4. Merge liquid from a transmission in the container.
5. After liquid plum from a transmission clear a carving on a drain stopper and in an opening of a case of a transmission. Establish a new sealing washer on a masloslivny stopper and screw in a stopper in a case of a transmission and tighten it the demanded moment. Lower the car on the earth.
6. Fill in in an automatic transmission demanded number of transmission of this liquid, then check liquid level.
7. Start the engine in an idling mode for some minutes. Switch off the engine and check level of transmission liquid in a transmission. If necessary add liquid. Make control check and repeatedly check level of transmission liquid.