Opel Vectra A

since 1988-1995 of release

Repair and car operation

Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13.10. Central console
   13.11. Switches подрежима
   13.12. Electronic control device (ECU)
   13.13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13.14. Hoses and tubes of a radiator of cooling of transmission liquid
   13.15. Replacement of sealing rings of differential
   13.16. Sensor of temperature of transmission liquid
   13.17. Sensors of speed of rotation of entrance and target shaft
   13.18. Removal and installation of an automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions


13.6. Switch of blocking of a starter


1. Tighten the hand brake and establish the selector lever in situation N.
2. Remove a weight wire from the accumulator.
3. Unscrew a nut and remove a pipe for щупа measurements of level of liquid / a bulk mouth.
4. Release a clamp, remove a washer and disconnect a switching cable from a control lever on a transmission.
5. Disconnect the electric socket from the switch.
6. Flat-nose pliers fix a shaft from a provorachivaniye, then unscrew a nut, fixing a control lever to a shaft of the lever of the selector. Wring out the uvula of a plate holding a nut from a provorachivaniye and unscrew a big nut with a washer, fixing the switch to a shaft. Unscrew a clamp which the switch to a transmission fixes.


1. Before installation check that the lever of a choice of transfers is established in situation N, i.e. the third situation from a forward part. Establish the switch on a shaft and screw in it against the stop switch cases in a reinforced surface of a shaft. Then tighten a switch clamp / a bulk mouth the demanded moment.
2. Being careful, tighten the demanded moment the big nut, fixing the switch to a shaft of the lever of a choice of transfers. Fix a nut from unscrewing for what bend a short mustache of a fixing plate.
3. For control lever installation by a transmission on a shaft of the lever of a choice of transfers by flat-nose pliers hold a shaft from a provorachivaniye and tighten a nut the demanded moment.
4. Establish a pipe for щупа level measurements / a bulk mouth with a new sealing ring which it is necessary to grease for simplification of installation. Tighten a nut of fastening of a pipe the demanded moment.
5. Connect to the switch the electric socket and a gear shifting cable, then check and, if necessary, adjust a cable.